Micro Grinding Mill

We're here to help:
Easy ways to get the answers you need. Service Online

Summer Micro Grinding Mill maintenance guide

                        

At present, most cities in the country have entered the hot summer season. For those who deal with Micro Grinding Mills every day, you should pay attention to how to ensure that the Micro Grinding Mill can overcome the high temperature and survive the summer. We will give you a brief introduction to the tips for using the summer Micro Grinding Mill.

1. Clean the Micro Grinding Mill. Clean the inside and outside of the Micro Grinding Mill parts, the body, grinding ring, grinding roller, motor, belt, gear connection, etc., all the places that can be cleaned should be cleaned. The purpose of this is to find out if there are any vulnerabilities, and do a full & ldquo; body” check.

2, the summer temperature rises, the sun often bursts, the Micro Grinding Mill paint surface is easy to peel off, and it often rains, causing the water vapor to easily accelerate the aging of the Micro Grinding Mill parts. At this time, pay attention to the place where the paint is damaged.

3, to prevent the body from overheating, should observe the indoor and outdoor temperature at the moment of grinding, pay attention to the temperature of the body should not exceed 100 & deg; If the indoor temperature is too high, the heating rate of the body will increase. At this time, ventilation should be prepared. If necessary, install a high-power exhaust fan to cool the room.

4. The faults of the Micro Grinding Mill equipment are listed as a table. From easy to difficult, one by one, the same fault cannot be repeated, especially the safety fault should be eliminated.

5, after the maintenance and repair, the mechanical equipment will be placed in a flat and solid venue, and can be parked in a dedicated hangar.

Micro Grinding Mill running-in period common problems and solutions

After the installation of the Micro Grinding Mill, it will take a period of running-in period to make the parts of the Micro Grinding Mill more harmonious. In addition, it can also find some problems through the debugging of this time, and solve it in time. To ensure the smooth progress of the grinding work in the future, we have summarized some small problems that the Micro Grinding Mill may encounter during the running-in period, and take it out and analyze it with everyone.

1. The newly processed and assembled parts have deviations in geometric shape and matching size. In the initial stage of use, due to the alternating load such as impact and vibration, as well as the influence of heat and deformation, and the wear and tear, etc., It is easy to loosen the parts that were originally tightened.

2. Leakage may occur due to the looseness of the machine, the vibration and the heat of the machine, the sealing surface of the machine and the pipe joints.

3. Due to insufficient understanding of the structure and performance of the Micro Grinding Mill machine (especially new operators), it is easy to cause malfunction due to operational errors, and even cause mechanical accidents.

4. Due to the influence of factors such as processing, assembly and adjustment of the new Micro Grinding Mill parts, the friction surface is rough, the contact area of ​​the mating surface is small, and the surface pressure is uneven. Therefore, it is easy to cause wear of parts (especially the matching surface) during the running-in period, and the wear speed is fast.

If the Micro Grinding Mill has the above problems during the running-in, please don’t worry too much, and don’t doubt the quality of the machine, because these problems are some unavoidable problems, as long as you take care of the Micro Grinding Mill during the running-in period, you find If the problem is solved in time, it will not cause any problems for your normal production in the future.

Send A Message

You can get the price list and a SBM representative will contact you within one business day.